PSC FALCON 315 Uživatelská příručka stáhnout pdf (Strana 82)

The Falcon Dock

58 Falcon

DOS Portable Terminals

2. Plug the other end into an outlet or power strip.

3. The red light-emitting diode (LED) labeled

POWER on the front panel

of the Falcon Dock should light up.

The power adapter is used only to recharge the batteries in the Falcon

31X or

32X.

•The

Ready light indicates that the Falcon is properly inserted in the

dock.

•The

Ready light appears red when charging and green when fully

charged.

In the Falcon

33X and 34X, the dock’s power must be on for serial communica-

tion to occur.

Using the Falcon Dock

Set up the Falcon Dock as described in the preceding sections. Refer to

Chapter 9 for information on troubleshooting problems with the Falcon Dock.

1. Place the Falcon into the dock, with the keypad facing the front.

2. If a power adapter is being used, the green LED labeled

Ready on the

front panel of the Falcon Dock lights up.

While the Falcon is in its dock:

• Programs can be downloaded into the Falcon or data returned from it

just as if it were connected directly to the computer.

• The Falcon can be left in the dock while using an attached bar code

reader.

• The Falcon Dock can be used to recharge either nickel-cadmium

(NiCD) or nickel metal hydride (NiMH) battery packs.

Leave the battery pack in the Falcon when placing it in the dock. The

battery pack and the lithium backup battery will be recharged while the

Ready light is on.

The LED indicators on the Falcon Dock will not light up if the power adaptor is

not used. Serial communications will operate normally even though the indica-

tor LEDs will remain dark without the adapter.

2314.book Page 58 Wednesday, June 9, 2004 8:30 AM

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 115 116

Žádné komentáře

PSC FALCON 315 Uživatelská příručka Strana 82